Nick that boat looks awsome

Terry momentarily delayed!

Awww who gives a fuck anyways, cant even make the damn video work.

Wow instead of two time in reverse it took me 3 !! Actually I had to drop down to the second hole in that spot the top pin wasn't enough !!

or reach back and pull a pin. then lower motor one hole and replace pin. No tools were used and took about 20 seconds. I know this and i don even own a gtr. Unlike you however, i am not oblivious to everything that is not my brand.

If it makes you feel better I had to do it about 3-4 times yesterday !! That's with a 32" shaft!! Middle pin is were I should have been the hold time but top is all I needed most of the time !! I think Craig did better than me with a 27" shaft on the bottom pin!!

Even when I had a nut on my bolt I never had to get out my boat to move it!! I think that is just a little bit much!! But if that's all you got to come back with well !!

In the process of machinig a custom Pin for my boat as we speak, RObert4wd is taking care of it, and terry is right if the 32" shaft has trouble in the top hole, the shiat is bad, i can vouch for that, been there. But left shortly after is was dropped down a hole.

I have a quick disconnect being fabbed up. My motor runs best in the top trim position. If in SETX mud I don't even run with the pin.

I see Justin posted for me.

How does a mb handle the mud like that? We've been getting the low down on gtrs, pd, and gds but no word on mb.

you mean to tell me there's competition out there, hmmmmmm never would have thunk it

Terry how did the duals do in the mud? Did it perform the same if not better than a single engine... If I recall you have a 2060? Just curious how it was not being able to really move the motor back & forth like when on the tiller. From the videos it looked like it did great. Other than pulling the pin if you needed to get motor down deeper any drawbacks to the 2060 duals vs 1860 single modded?

Coe that wasn't my dual rig!! But as big and heavy as it was it did well in the mud

Gotcha

I would say this though after seing that boat yesterday a set of them on a open floor light 18x60 built light would be the shit lol!!