|
FAQ
• Login
|
|
It is currently Sun Jun 09, 2024 1:17 pm
|
|
Page 1 of 1
|
[ 4 posts ] |
|
short PRO DRIVE to long??
Author |
Message |
DennisB.
MMT Pro Member
Joined: Sat Jan 17, 2009 9:13 pm Posts: 97 Location: half up a tree
|
short PRO DRIVE to long??
How hard is it to make this motor a long shaft??? I know there is some welding involved??
_________________ CVN73 Plank owner
Bad spellers of the world untie!!!!!
|
Sat Apr 18, 2009 6:50 am |
|
|
texman034
MMT Pro Member
Joined: Wed Feb 25, 2009 5:51 pm Posts: 76
|
Re: short PRO DRIVE to long??
I just had my 32 converted a few weeks ago. It cost about $300 out the door. I had it done at the PD shop, and they had it knocked out in a couple of hours.
_________________ Work harder --- Live better.
|
Sat Apr 18, 2009 5:48 pm |
|
|
idabilly
MMT Addict
Joined: Sat Jan 17, 2009 7:17 pm Posts: 617 Location: Idaho
|
Re: short PRO DRIVE to long??
Not the hardest project in the world. Just did it last week. Two guys doing it for the first time took maybe four hours, and that was really taking our time.
You do have to weld aluminum on the outer housing.
If Texman was saying that you could get out the door with parts and labor included for $300 and you are close enough to carry your motor over to them you should jump on that deal.
|
Sun Apr 19, 2009 9:53 pm |
|
|
oneneo3
MMT Member
Joined: Tue Jan 20, 2009 2:47 pm Posts: 42 Location: Kingwood, Tx
|
Re: short PRO DRIVE to long??
_________________ Git while the gitn's good...
|
Mon Apr 20, 2009 1:20 pm |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 150 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|