Nice job!! One of those will look good on my rig...
| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Prodrive Trailer Bracket http://mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=20405 |
Page 1 of 1 |
| Author: | daddymallard [ Thu Jul 28, 2011 8:59 am ] |
| Post subject: | Prodrive Trailer Bracket |
Just thought i would throw out an idea we came up with to keep your PD from swinging around while trailering. We cut a wood 2x4 first but found that after a few trips down some dirt roads that the PD chewed it up pretty easy. After some searching on the net I found a website that sold small "blocks" of UHMW. I bought one that was 1.75"x12"x12". Used a skilsaw to cut it and a band saw to notch it. Works extremely well and is tough as nails! |
|
| Author: | duckhunter888 [ Thu Jul 28, 2011 9:06 am ] |
| Post subject: | Re: Prodrive Trailer Bracket |
Post up the link to the website as I'm interested in this. By the looks of the picture is the PD mostly straight up and down? |
|
| Author: | daddymallard [ Thu Jul 28, 2011 12:51 pm ] |
| Post subject: | Re: Prodrive Trailer Bracket |
Yeah the motor is pretty straight up and down but angle doesnt matter. http://www.onlinemetals.com/merchant.cf ... op_cat=181 |
|
| Author: | oncall [ Thu Jul 28, 2011 3:42 pm ] |
| Post subject: | Re: Prodrive Trailer Bracket |
Nice job!! One of those will look good on my rig...
|
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|