GT has been sitting up for about 4 weeks so I went out yesterday to start it up. Motor started fine, idled, reversed, everything worked. Went ahead and trimmed up from trailering bracket and then trimmed it back down. During down trim, it stopped working. Tried several more times and got nothing. Shut motor off, pulled switch cover (new one on tiller), to see if any wires had come loose. All connected and no corrosion. So I tried to trim again, nothing. Turned key to on position and switched clutch from start to forward to see if it was clicking at back of motor. It was intermittent at best. Would flip switch several times before I could get it to engage. Trim still won't work. Any Ideas??
Don't know of any fuses between either of them. Also, when GT put on the new control box, they had to replace the diodes in the motor (kept blowing fuses).