| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| GDSD 35hp bushing http://mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=22678 |
Page 1 of 1 |
| Author: | beauxabby [ Thu Sep 29, 2011 10:35 pm ] |
| Post subject: | GDSD 35hp bushing |
ok i need to replace the bushing that holds the motor to the transom clamp, it came with a rubber/plastic/teflon looking material, GD sent me some brass bushings to replace them . looking for some tips/advice on changing them out. right now my engine will wobble left to right pretty bad Thanks |
|
| Author: | T-Bubba [ Fri Sep 30, 2011 2:12 am ] |
| Post subject: | Re: GDSD 35hp bushing |
i thought godevils didnt break and need new parts |
|
| Author: | Quack Head [ Sun Oct 02, 2011 7:05 pm ] |
| Post subject: | Re: GDSD 35hp bushing |
Replaced mine last year and it was not the easiest thing to do. The bushing fits tight so I had to beat them in w/a hammer. Just becareful not to bend them up, if I remember they are brass. When you knock the pin back in start the nut on one side just enough to prevent from damaging the treads when tapping it w/hammer. Oh and I lifted mine up w/ a chain hoist then lower back the same way. It easier to have someone helping you align holes when putting pin back in. I'm no pro but hope this helped |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|