Maybe grease that Mofo?
| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| For those that have a GTR... http://mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=29399 |
Page 1 of 1 |
| Author: | NFW [ Tue May 22, 2012 11:20 am ] |
| Post subject: | For those that have a GTR... |
I've noticed when I run across dry land or something of the sort that will kick your motor up. Well for a while now when if kicks up good it tends to stay up and I have to nudge with my butt back down. Well about half the time I push it back down I flip it into neutral. Not the best then went goin across shallow hard bottom. Was wondering if I can do something so that when it kicks up it'll good back down by itself. |
|
| Author: | Beadlejuicejr [ Tue May 22, 2012 11:25 am ] |
| Post subject: | Re: For those that have a GTR... |
Don't butt hump it. Reach back and push it down |
|
| Author: | deltaduckmaster [ Tue May 22, 2012 11:26 am ] |
| Post subject: | For those that have a GTR... |
That all depends on were your trim is located !! Get the box upgrade will move everything to your handle |
|
| Author: | WestEndAngler [ Tue May 22, 2012 12:16 pm ] |
| Post subject: | Re: For those that have a GTR... |
Also that custom handle Terry has on his single gtr is pretty cool. |
|
| Author: | marsh chicken [ Tue May 22, 2012 12:27 pm ] |
| Post subject: | Re: For those that have a GTR... |
| Author: | WestEndAngler [ Tue May 22, 2012 12:30 pm ] |
| Post subject: | Re: For those that have a GTR... |
| Author: | CJB [ Tue May 22, 2012 12:37 pm ] |
| Post subject: | Re: For those that have a GTR... |
Couple shots here... viewtopic.php?f=5&t=6817&start=0 |
|
| Author: | NFW [ Tue May 22, 2012 3:58 pm ] |
| Post subject: | Re: For those that have a GTR... |
Well usually one had on filler and one hand grab bar don't like take the risk of taking hand off the grab bar though. But any input of what I can do without spending money |
|
| Author: | Robn1020 [ Tue May 22, 2012 4:49 pm ] |
| Post subject: | Re: For those that have a GTR... |
| Author: | CJB [ Tue May 22, 2012 4:54 pm ] |
| Post subject: | Re: For those that have a GTR... |
| Author: | Woodiebuster [ Tue May 22, 2012 5:06 pm ] |
| Post subject: | Re: For those that have a GTR... |
Maybe grease that Mofo?
|
|
| Author: | Skipr [ Tue May 22, 2012 5:19 pm ] |
| Post subject: | Re: For those that have a GTR... |
I haven't had that problem, mine falls back into place by itself. I also upgraded to the control box on the handle as previously mentioned. The main reason i did this is because there are no crappy relays with the new control box. I haven't had any trim issues since. |
|
| Author: | deltaduckmaster [ Tue May 22, 2012 5:34 pm ] |
| Post subject: | For those that have a GTR... |
Nfw what kind of boat you run!! Reason I ask if the transom angle is less it will change the pivot point |
|
| Author: | Will [ Tue May 22, 2012 5:44 pm ] |
| Post subject: | Re: For those that have a GTR... |
He has a gator tail hull. |
|
| Author: | take'emgator [ Tue May 22, 2012 5:48 pm ] |
| Post subject: | Re: For those that have a GTR... |
Got damn son your hit seomthing hard for it to kick up and stay up, lmao thats wild, X2 ddm with th transom angle |
|
| Author: | deltaduckmaster [ Tue May 22, 2012 7:27 pm ] |
| Post subject: | For those that have a GTR... |
Ok what hole are you running on it!! I notice mine does it slot Aldo but only when it's trimmed up high!! It will do it alot if it's on the top hole!! |
|
| Author: | marsh chicken [ Tue May 22, 2012 11:44 pm ] |
| Post subject: | Re: For those that have a GTR... |
| Author: | NFW [ Wed May 23, 2012 6:31 am ] |
| Post subject: | Re: For those that have a GTR... |
Just the middle hole. Idk it just get real annoying when it stays up cause that the cause of me gettin stuck like 90% of the time. |
|
| Author: | skinnerton_outlaw [ Wed May 23, 2012 5:30 pm ] |
| Post subject: | Re: For those that have a GTR... |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|