| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| prodive? http://mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=29617 |
Page 1 of 1 |
| Author: | thai1984 [ Fri Jun 01, 2012 12:31 pm ] |
| Post subject: | prodive? |
can you get or cut down a pro drive prop to 9 inches for hunting fed. lands? |
|
| Author: | med [ Fri Jun 01, 2012 12:35 pm ] |
| Post subject: | Re: prodive? |
Trim down in the sand and hammer on it. Shouldn't take long. |
|
| Author: | cb5331 [ Fri Jun 01, 2012 12:44 pm ] |
| Post subject: | Re: prodive? |
Lol |
|
| Author: | Woodiebuster [ Fri Jun 01, 2012 12:49 pm ] |
| Post subject: | Re: prodive? |
just put the prop in a chop saw and cut 2.5" off each blade. |
|
| Author: | Will [ Fri Jun 01, 2012 1:21 pm ] |
| Post subject: | Re: prodive? |
Then it would be 7 1/2" |
|
| Author: | Woodiebuster [ Fri Jun 01, 2012 2:37 pm ] |
| Post subject: | Re: prodive? |
it would be even faster than a 9" |
|
| Author: | eljefe [ Sat Jun 02, 2012 6:09 am ] |
| Post subject: | Re: prodive? |
Yep seen it done....works ok in water....totally sux in mud....small prop lots of cup results in blowouts in the mud.... |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|