MudmotorTalk.com
http://mudmotortalk.com/mmt_v2/

Hard to turn at speed especially tubing
http://mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=29982
Page 1 of 1

Author:  daddyflea [ Fri Jun 15, 2012 7:14 am ]
Post subject:  Hard to turn at speed especially tubing

I got a 23 GDSD with the Rock Guard. At speed my Motor floats and does not run against the Trim stops. I actually have good speed and it pulls good.

The problem is there is no way you can make anything near a sharp turn at speed with out letting off the gas. I took off my Rock Guard hoping this will help. Have not been able to try the boat since removing the Rock Guard.

Hopefully soon I will have a video of the Kids tubing behind the boat. Got the video just can not get it transferred on here.

Author:  Woodiebuster [ Fri Jun 15, 2012 8:22 am ]
Post subject:  Re: Hard to turn at speed especially tubing

Nature of the beast, is it trying to blow out of the water when you do that?

Author:  daddyflea [ Fri Jun 15, 2012 8:47 am ]
Post subject:  Re: Hard to turn at speed especially tubing


Author:  mizzippi jb [ Sat Jun 16, 2012 2:00 pm ]
Post subject:  Re: Hard to turn at speed especially tubing

because its a not a round chine boat, its not gonna turn on a dime at on step speed

Author:  elebouef102 [ Sat Jun 16, 2012 2:14 pm ]
Post subject:  Re: Hard to turn at speed especially tubing


Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/