| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| tall ransom boat short shaft surface drives info http://mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=58757 |
Page 1 of 1 |
| Author: | Keebler [ Wed Dec 17, 2014 8:22 pm ] |
| Post subject: | tall ransom boat short shaft surface drives info |
| Author: | North LA Hunter [ Wed Dec 17, 2014 8:52 pm ] |
| Post subject: | Re: tall ransom boat short shaft surface drives info |
I'm sure it will go but not well at all. I wouldn't waste my money. And I'm guessing you mean short transom? Sent from my beeper |
|
| Author: | btmannin [ Wed Dec 17, 2014 8:57 pm ] |
| Post subject: | Re: tall ransom boat short shaft surface drives info |
^^ this.... But if your gettin a smoking deal on it or something you could always cut the transom down. |
|
| Author: | rhock19 [ Wed Dec 17, 2014 9:45 pm ] |
| Post subject: | Re: tall ransom boat short shaft surface drives info |
Yeah I did that on my copperhead. They dont offer tall transom so I got the short and cut the transom down. Ran it once while the transom was 20" and it went but not nearly the pace when cut and had no digging length whatsoever |
|
| Author: | banded-mallard [ Thu Dec 18, 2014 5:46 am ] |
| Post subject: | Re: tall ransom boat short shaft surface drives info |
| Author: | Keebler [ Thu Dec 18, 2014 9:22 am ] |
| Post subject: | Re: tall ransom boat short shaft surface drives info |
I didn't figure I'd work just thought some one might have come up with something thanks guys |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|