MudmotorTalk.com
http://mudmotortalk.com/mmt_v2/

Hydro turf application?
http://mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=72857
Page 1 of 1

Author:  Pinhead pat [ Tue Aug 14, 2018 6:26 pm ]
Post subject:  Hydro turf application?

I bought a roll of hydro turf off ebay for cheap. It doesnt have any 3M backing. What are the best ways to stick it to your boat that yall have seen hold up to time and abuse. Thanks in advance


Sent from my iPhone using Tapatalk

Author:  Russ [ Tue Aug 14, 2018 6:50 pm ]
Post subject:  Re: Hydro turf application?

3m spray adhesive

#CFFITR
#TheGhostBoat
#whoneedsphysicsihaveamudmotor

Author:  Bigbend [ Tue Aug 14, 2018 7:38 pm ]
Post subject:  Re: Hydro turf application?

^ what he said

Author:  Pinhead pat [ Wed Aug 15, 2018 9:55 pm ]
Post subject:  Re: Hydro turf application?


Author:  ddhawkfan [ Thu Aug 16, 2018 6:04 am ]
Post subject:  Re: Hydro turf application?

I used 3m hi-strength 90

Author:  warrenwaterfowler [ Thu Aug 16, 2018 6:43 am ]
Post subject:  Re: Hydro turf application?

Roll DAP contact cement on the back off the hydroturf and on the surface it's going on and let it set until it's tacky-almost dry. Then apply hydroturf and press it into place. Done....will not move or come loose

Author:  KJH [ Thu Aug 16, 2018 9:51 am ]
Post subject:  Re: Hydro turf application?


Author:  ibfishinb [ Sat Aug 18, 2018 12:38 pm ]
Post subject:  Re: Hydro turf application?

Did mine with contact cement. Holds it great but reacts with the turf and allows it to expand a bit.

Sent from my SM-G920V using Tapatalk

Author:  MNGunner [ Sat Aug 18, 2018 1:01 pm ]
Post subject:  Re: Hydro turf application?


Author:  Russ [ Sat Aug 18, 2018 1:32 pm ]
Post subject:  Re: Hydro turf application?

Loctite makes a spray adhesive that's good too. You're not trying to hold a car up in the air that's glued to the bottom of an airplane. The 3m stuff is fine, and is quite similar in bond strength to the stuff that comes preapplied. There are a half a dozen other options, too, that would work as well. Just pick one, clean the boat surface properly (which will matter more than whether you use contact cement, 3m spray, or elephant jizz, then apply and roll out.

#CFFITR
#TheGhostBoat
#whoneedsphysicsihaveamudmotor

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/