| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Prodrive Hydraulic trim slipping http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=13148 |
Page 1 of 1 |
| Author: | roadgoeson20 [ Sun Oct 17, 2010 8:17 pm ] |
| Post subject: | Prodrive Hydraulic trim slipping |
lately my motor seems to slip down all the way to the lowest point. It's like the hydraulic trim isn't holding it up for any length of time at all. Anyone else experienced this? Ideas? Thanks |
|
| Author: | duckhunter888 [ Sun Oct 17, 2010 8:20 pm ] |
| Post subject: | Re: Prodrive Hydraulic trim slipping |
I would recommend to call PD. |
|
| Author: | Phathead [ Sun Oct 17, 2010 9:11 pm ] |
| Post subject: | Re: Prodrive Hydraulic trim slipping |
Have you checked the fluid level. These things must have the correct amount of fluid to work properly. Unscrew fill cap and check the level via the guage on the dipstick. If it is low add dexron III transmission fluid to the proper level, put cap back on and run it up and down to get air out of lines and see what happens. |
|
| Author: | UNCLE-J [ Mon Oct 18, 2010 7:49 am ] |
| Post subject: | Re: Prodrive Hydraulic trim slipping |
| Author: | Brinkleydog [ Mon Oct 18, 2010 4:06 pm ] |
| Post subject: | Re: Prodrive Hydraulic trim slipping |
only when i busted and pump or line.....you got any fluid on the deck? |
|
| Author: | sedlmayrje1723 [ Mon Oct 18, 2010 6:05 pm ] |
| Post subject: | Re: Prodrive Hydraulic trim slipping |
What kind of motor do you have this on? I am thinking about getting power trim for my stage 3. Do you guys think it would hold up? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|