| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| tunnel on mud motor http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=18209 |
Page 1 of 1 |
| Author: | byler11 [ Mon May 02, 2011 8:46 am ] |
| Post subject: | tunnel on mud motor |
Will tunnels wrk on a prodrive motor. If not. What about a jack plate to get the motor higher or weld up the tunnel. Please give me feed back |
|
| Author: | OwenDickeson [ Mon May 02, 2011 8:50 am ] |
| Post subject: | Re: tunnel on mud motor |
Close the tunnel. |
|
| Author: | byler11 [ Mon May 02, 2011 12:54 pm ] |
| Post subject: | Re: tunnel on mud motor |
would a jack plate help at all to get the motor high enough |
|
| Author: | OwenDickeson [ Mon May 02, 2011 1:00 pm ] |
| Post subject: | Re: tunnel on mud motor |
Mud motors arent meant to run on tunnel hulls. Fill it in, you will be happier. |
|
| Author: | byler11 [ Mon May 02, 2011 5:07 pm ] |
| Post subject: | Re: tunnel on mud motor |
thanks for the feedback |
|
| Author: | fillinthetunnel [ Tue May 03, 2011 8:42 pm ] |
| Post subject: | Re: tunnel on mud motor |
fill it in! |
|
| Author: | POKER1 [ Tue May 03, 2011 8:52 pm ] |
| Post subject: | Re: tunnel on mud motor |
Fill it in. The prop is already running on the surface. |
|
| Author: | pooldoo73 [ Wed May 04, 2011 1:06 am ] |
| Post subject: | Re: tunnel on mud motor |
How would it run on a tunnel hull if hydraulic jack plate? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|