MudmotorTalk.com http://mudmotortalk.com/mmt_v2/
35 briggs stock cylinder tolerances http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=20881	Page 1 of 1

---

Author:	Jamie B. [ Wed Aug 10, 2011 5:12 pm ]
Post subject:	35 briggs stock cylinder tolerances
Does anybody know the stock tolerances for the cylinders for a 35 briggs

---

Author:	cb5331 [ Wed Aug 10, 2011 5:16 pm ]
Post subject:	Re: 35 briggs stock cylinder tolerances
Pretty sure they are listed in the service manual. I'll look when I get home if I remember.

---

Author:	Jamie B. [ Wed Aug 10, 2011 5:20 pm ]
Post subject:	Re: 35 briggs stock cylinder tolerances
do you have a link for the service manual? thanks in advance

---

Author:	cb5331 [ Wed Aug 10, 2011 5:23 pm ]
Post subject:	Re: 35 briggs stock cylinder tolerances
Na, unforutunately Briggs makes you buy one. I'm bout to log off to head home. Send me a PM in a lil while to remind me and I'll check for you. We just had one bored out for .020 overs and I'm pretty sure I came across those numbers when we were doing that.

---

Author:	cb5331 [ Wed Aug 10, 2011 6:57 pm ]
Post subject:	Re: 35 briggs stock cylinder tolerances
Stock bore 3.336 Reject dimension 3.369 Out of round .002 Main Bearing stock dimension 1.775 Reject 1.777 Cam bearing stock dimension .630-.631 Reject .633 That should be whatcha need. If you need any other numbers, just let me know and I'll look em up for you if I can. Get you a service manual on order though if you don't have one, awfully handy to have around.

---

Author:	deadbird8 [ Thu Aug 11, 2011 8:32 pm ]
Post subject:	Re: 35 briggs stock cylinder tolerances

---

Author:	cb5331 [ Fri Aug 12, 2011 6:43 am ]
Post subject:	Re: 35 briggs stock cylinder tolerances

---

Author:	deadbird8 [ Sat Aug 13, 2011 4:57 pm ]
Post subject:	Re: 35 briggs stock cylinder tolerances

---

Page 1 of 1	All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/