| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Intake Porting http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=20961 |
Page 1 of 1 |
| Author: | Snowbird [ Fri Aug 12, 2011 5:38 pm ] |
| Post subject: | Intake Porting |
Has anyone here done some port and polish on their stock carb's intake? any tips or just clean up the factory slop? |
|
| Author: | Snowbird [ Fri Aug 12, 2011 5:56 pm ] |
| Post subject: | Re: Intake Porting |
| Author: | jordy [ Fri Aug 12, 2011 8:56 pm ] |
| Post subject: | Re: Intake Porting |
I'm interested to know what kind of gains this will produce......? |
|
| Author: | Snowbird [ Fri Aug 12, 2011 9:43 pm ] |
| Post subject: | Re: Intake Porting |
| Author: | deadbird8 [ Sat Aug 13, 2011 5:16 am ] |
| Post subject: | Re: Intake Porting |
I did a lot of them, as well as gasket matching, you can relax the 90 degree turns and smooth out the flow. Theres a post on the site you just registered on. Increasing the flow gives some RPM and better accelleration. |
|
| Author: | po po mud duck [ Sat Aug 13, 2011 8:12 am ] |
| Post subject: | Re: Intake Porting |
| Author: | dguidry [ Sat Aug 13, 2011 8:29 am ] |
| Post subject: | Re: Intake Porting |
The work done in those pics looks nice. I know that results in better flow but what is the improvement in real numbers: torq, rpms, mph? Anyone have dyno stats for porting and polishing like this? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|