| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| another mikuni carb question http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=23209 |
Page 1 of 1 |
| Author: | Jamie B. [ Tue Oct 18, 2011 7:13 pm ] |
| Post subject: | another mikuni carb question |
Just finished putting my motor together finally, well i installed over size intake vavles and cant get it to idle worth a crap. With the airmixture screw tightened all the way down down it idles the best my question is, the sizing on the pilot jets are they bigger bores the smaller the #? ( say for instance a 22.5 is bigger than a 25? thanks Jamie B |
|
| Author: | pokey79 [ Tue Oct 18, 2011 7:22 pm ] |
| Post subject: | Re: another mikuni carb question |
the bigger the number the bigger the hole!! |
|
| Author: | Jamie B. [ Tue Oct 18, 2011 8:01 pm ] |
| Post subject: | Re: another mikuni carb question |
I know that is how the highspeed jet is te bigger the # the bigger the bore, but wasnt sure on the pilot jets . |
|
| Author: | craig [ Tue Oct 18, 2011 8:24 pm ] |
| Post subject: | another mikuni carb question |
Bigger the number, bigger the jet size. |
|
| Author: | Jamie B. [ Wed Oct 19, 2011 8:03 am ] |
| Post subject: | Re: another mikuni carb question |
yes sprayed crawl all around intake flanges and car boot no pick up in idle. Kinda got me stumped how i made a few changes with mods on this motor and was running a 22.5 pilot jet and i would need to change at idle to a bigger size. Thanks Jamie B |
|
| Author: | DMC [ Thu Oct 20, 2011 10:55 am ] |
| Post subject: | Re: another mikuni carb question |
Make sure the choke valve is seated. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|