| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Calens engine service http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=24905 |
Page 1 of 1 |
| Author: | DaDuckDaddy [ Wed Dec 14, 2011 10:41 am ] |
| Post subject: | Calens engine service |
Have to give a big thanks to Calen. I called him the Thursday before the split season told him about how my crankcase gasket was leaking and that I would be making a hunt in the wax the suday of closing weekend and that I'd like to drop it off on Sunday so I wouldn't have to make a trip back and also that I needed it for the following weekend . He said that was fine. Met him suday after my hunt and while i was dropping my boat off I decided to throw the cam in there while he had it apart. Thursday my boat was ready. I got off work late and Calen still came meet me at his shop at 8 that night to pick up my boat. Now that's good customer service if I do say so myself. I reccomend him to anyone needing service work or looking to get performance work done. |
|
| Author: | cb5331 [ Wed Dec 14, 2011 10:43 am ] |
| Post subject: | Re: Calens engine service |
What cam? How's it run? |
|
| Author: | da_quack_meister [ Wed Dec 14, 2011 10:56 am ] |
| Post subject: | Re: Calens engine service |
X2 on customer service. During the first split running back from the delta, my brake caliper locked up. I took it to him straight from the launch, so he could get a look at it. During his examination he noticed that the crank case cover was cracked also. I am limited to my hunting days becasue of work and Calen had the Boat ready the Next day. Couldn't ask for better service anywhere. He got all that done and killed a limit of ducks that morning, LOL. I am looking forward to him doing my stage 1 after the season. |
|
| Author: | DaDuckDaddy [ Wed Dec 14, 2011 12:12 pm ] |
| Post subject: | Re: Calens engine service |
He put hoyts cam in it. I gained about 2.5 mph and a noticeable increase in power. I was running 29.5 average with 2 guys, 4 dozen dekes, 9 gallons of gas, a full ice chest and normal huntin stuff before cam. And I ran 32 mph this weekend with same load, but now im turning 4220-4260 Rpms and bumping the rev limiter once in a while. And before the cam 5 guys, 9 gallons of gas, and a full ice chest i got 25 mph and I got 27 mph after cam and even bumped 28 a couple times. |
|
| Author: | deltaduckmaster [ Wed Dec 14, 2011 12:25 pm ] |
| Post subject: | Calens engine service |
What else do you have done to your motor besides a cam |
|
| Author: | cb5331 [ Wed Dec 14, 2011 12:26 pm ] |
| Post subject: | Re: Calens engine service |
Sig says heads, carb, and exhaust. |
|
| Author: | DaDuckDaddy [ Wed Dec 14, 2011 12:59 pm ] |
| Post subject: | Re: Calens engine service |
Iron mountain heads, carb, mm exhaust |
|
| Author: | da_quack_meister [ Wed Dec 14, 2011 1:09 pm ] |
| Post subject: | Re: Calens engine service |
I was wondering if the mikuni along with a stage 1 would be to much. How easily do you get to the rev limiter. I like the speeds, hope I can get that out of my 1854 CC. I hunt the ADWMA, delta side, hunted the wax for a while. And I carry large loads down to the camp. I am like a push barge in the ICW till I hit some shallows and pick up my speed. Calen told me that the stage 1 will cure that. |
|
| Author: | DaDuckDaddy [ Wed Dec 14, 2011 1:25 pm ] |
| Post subject: | Re: Calens engine service |
I haven't been able to hit shallows yet to see how quick it'll hit the rev limiter... That'll be the real test... But in deep water with Juss two guys i keep it at 4250. If I trim up a Lil more it'll hit the rev limiter... I'm sure I might be able to pick up a Lil more speed if I were able to trim up a Lil more.. Might just end up having to get some high rev coils. |
|
| Author: | Jamie B. [ Wed Dec 14, 2011 1:53 pm ] |
| Post subject: | Re: Calens engine service |
Nice, that is great to hear a dealer taken care of his customers in a timely fashion. If you want to install high rev coils give me a call, ill give you a hand. |
|
| Author: | DaDuckDaddy [ Wed Dec 14, 2011 2:40 pm ] |
| Post subject: | Re: Calens engine service |
Alright Ill Proly be givin ya a call after hunting season. I'm thinkin about doing that and I'd like to maybe do something with some new heads if I can get my hands on some. |
|
| Author: | Jamie B. [ Wed Dec 14, 2011 6:40 pm ] |
| Post subject: | Re: Calens engine service |
just let me know, I am ready when you are. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|