MudmotorTalk.com
http://mudmotortalk.com/mmt_v2/

Idle problems
http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=26454
Page 1 of 1

Author:  maverick [ Mon Feb 06, 2012 1:57 pm ]
Post subject:  Idle problems

So I have a 36pd 08 model so when I go to engage the clutch it will not idle out, I have to milk the throttle for it to not die looking for any solutions to fix this

Author:  craig [ Mon Feb 06, 2012 1:58 pm ]
Post subject:  Re: Idle problems

What rpm is it idling at?

It should be 1100-1200.

Author:  maverick [ Mon Feb 06, 2012 2:02 pm ]
Post subject:  Re: Idle problems

No it's not it's around 900 or so

Author:  duckduckboom [ Mon Feb 06, 2012 4:18 pm ]
Post subject:  Re: Idle problems


Author:  deltaduckmaster [ Mon Feb 06, 2012 4:44 pm ]
Post subject:  Idle problems

Instead If adjusting your idle with the carb setting adjust by bending arm on governor spring!!

Author:  robertb4wd [ Mon Feb 06, 2012 7:51 pm ]
Post subject:  Re: Idle problems

My motor was doing about the same thing, ended up being an intake valve.

Author:  maverick [ Mon Feb 06, 2012 9:01 pm ]
Post subject:  Re: Idle problems


Author:  duckduckboom [ Mon Feb 06, 2012 9:24 pm ]
Post subject:  Re: Idle problems

in neutral it should be around 1200 rpms

Author:  maverick [ Mon Feb 06, 2012 10:47 pm ]
Post subject:  Re: Idle problems


Author:  WestEndAngler [ Mon Feb 06, 2012 10:53 pm ]
Post subject:  Re: Idle problems


Author:  maverick [ Mon Feb 06, 2012 11:05 pm ]
Post subject:  Re: Idle problems


Author:  duckduckboom [ Mon Feb 06, 2012 11:10 pm ]
Post subject:  Re: Idle problems

there is a screw on top of your carb, turn right to rise idle until hits around 1200

Author:  WestEndAngler [ Mon Feb 06, 2012 11:13 pm ]
Post subject:  Idle problems


Author:  deadbird8 [ Tue Feb 07, 2012 4:34 am ]
Post subject:  Re: Idle problems

Turn up the idle first, 800 with stock coils in the water is low.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/