| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Another one bits the dust! http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=27319 |
Page 1 of 1 |
| Author: | Beadlejuicejr [ Fri Mar 02, 2012 6:16 pm ] |
| Post subject: | Another one bits the dust! |
Well went ahea an started changing out my case gasket a lil while ago cause it started another bp oil spill lastnight frogging. So I go ahead and pull the camshaft out just to check out the lobes make sure everything is in order hole I'm in there, well what do I get to find but yet another block F'ed up cam bushing GONE camshaft end screwed. Well, that makes two block in say a year. Don't get better than that |
|
| Author: | downdabayou [ Fri Mar 02, 2012 6:21 pm ] |
| Post subject: | Re: Another one bits the dust! |
Damn how many hours on this block |
|
| Author: | OwenDickeson [ Fri Mar 02, 2012 6:31 pm ] |
| Post subject: | Another one bits the dust! |
Who built the motor? |
|
| Author: | Beadlejuicejr [ Fri Mar 02, 2012 6:57 pm ] |
| Post subject: | Re: Another one bits the dust! |
I couldn't tell you how many hrs the hrs don't go up on it I'd say somewhere about 100 or so I built the motor with care oiled everything up soaked it before putting it in. The first one that did it was a stock motor that never been touched |
|
| Author: | Beadlejuicejr [ Sat Mar 03, 2012 2:43 am ] |
| Post subject: | Re: Another one bits the dust! |
They are just Shimed with I'm assuming same shims everyone uses |
|
| Author: | Calen [ Sat Mar 03, 2012 8:02 am ] |
| Post subject: | Re: Another one bits the dust! |
If your running the set of heads you got from me it's Definitely not spring tension. |
|
| Author: | pooldoo73 [ Sat Mar 03, 2012 10:27 am ] |
| Post subject: | Re: Another one bits the dust! |
That sucks. How long would it have run like that if u wouldn't have decided to change the case gasket when u did? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|