Does it shock the ever living shit out of you? Then you know your coil is out. Trust me.
| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| how to check diodes http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=28164 |
Page 1 of 1 |
| Author: | deaddrake [ Tue Apr 03, 2012 8:37 pm ] |
| Post subject: | how to check diodes |
i believe my coil went out on my 23 horse vanguard but i was told to check the diodes, how do i do this. |
|
| Author: | postalpaul [ Tue Apr 03, 2012 8:40 pm ] |
| Post subject: | Re: how to check diodes |
Volt ohm multimeter put it on ohms and read just the diode only nothing else connected Should read low(0-5) ohms one way and nothin (infinity) open thd other |
|
| Author: | postalpaul [ Tue Apr 03, 2012 8:41 pm ] |
| Post subject: | Re: how to check diodes |
http://www.allaboutcircuits.com/vol_3/chpt_3/2.html This ill help |
|
| Author: | Robn1020 [ Wed Apr 04, 2012 6:23 am ] |
| Post subject: | Re: how to check diodes |
Does it shock the ever living shit out of you? Then you know your coil is out. Trust me.
|
|
| Author: | garjacker [ Thu Apr 05, 2012 5:12 pm ] |
| Post subject: | Re: how to check diodes |
the diodes are there to protect feedback from one coil to the other. you dont need them to run. you can just unplug the terminal ground wiring harness and if it runs then its not the diodes. just be ready to choke the engine or smother the carb. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|