MudmotorTalk.com
http://mudmotortalk.com/mmt_v2/

I need some help on gtr 35
http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=29672		 Page 1 of 1
Author:  jpurpera3 [ Mon Jun 04, 2012 2:12 pm ]
Post subject:  I need some help on gtr 35
I'm looking for an affordable way to get noticeably more power out of my stock 35 gtr. Maybe a stage one tune up? And where can I purchase a tune ?
Author:  WestEndAngler [ Mon Jun 04, 2012 2:40 pm ]
Post subject:  Re: I need some help on gtr 35
Hoyt @ Gator-Tail in Loreaville, Boat Dr. in New Orleans Area or SETX Performance in Beaumont /Port Arthur area.

There is nothing "affordable" about these motors when it comes time to adding performance upgrades! Get ready to drop 300-500 on exhaust, 300 on a cam and some change on head work plus labor. If I were you I'd run exhaust, cam & modified stock heads w/ a stock carb assuming you're on a budget. You can always save & add the mikuni later but your noticeable load carrying ability will be from the heads & cam. When it was all said & done with the mods listed below I think cost me somewhere around $2,000 +/-

I did the following in this order:

1. Exhaust (SS)
2. Ran different carbs (stock carbs that were modified) - ended up going back to stock carb still looking for power
3. Won a set of port & polished stock heads on MMT Radio
4. Installed Mikuni, Heads & CAM for 2011 SETX Ride
5. Installed Roller Rockers & Heavy Duty Push Rods a week later
6. SS Valves added & reseated maybe 6 -8 months later

All of my work (#'s 3-6) were installed by Cody @ SETX Performance.
Author:  CJB [ Mon Jun 04, 2012 2:43 pm ]
Post subject:  Re: I need some help on gtr 35
Author:  WestEndAngler [ Mon Jun 04, 2012 2:44 pm ]
Post subject:  Re: I need some help on gtr 35
Author:  Woodiebuster [ Mon Jun 04, 2012 4:25 pm ]
Post subject:  Re: I need some help on gtr 35
I was thinkin to myself today we needed to do that, it was pretty fun.
Author:  woodysqueal23 [ Tue Jun 05, 2012 5:43 am ]
Post subject:  Re: I need some help on gtr 35
Not sure where u are in la. But calens engine service can do the stage 1 also. He is located in Franklin
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/