| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| 35 vanguard thin head gasket? http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=31060 |
Page 1 of 1 |
| Author: | jwoods823 [ Thu Jul 26, 2012 4:25 pm ] |
| Post subject: | 35 vanguard thin head gasket? |
Does anyone know if there are any thin head gaskets out there for a 35 vanguard. I have got twin Carbs and valve whims on the way and wanted to see about thinner metal head gaskets. PLEASE HELP |
|
| Author: | deadbird8 [ Thu Jul 26, 2012 4:54 pm ] |
| Post subject: | Re: 35 vanguard thin head gasket? |
?? |
|
| Author: | postalpaul [ Thu Jul 26, 2012 4:56 pm ] |
| Post subject: | Re: 35 vanguard thin head gasket? |
Huh |
|
| Author: | jwoods823 [ Thu Jul 26, 2012 6:03 pm ] |
| Post subject: | Re: 35 vanguard thin head gasket? |
Thinner head Gasket cause higher compression. Like decking the heads. They make copper gaskets for the 23 vanguard that are .03 thinner than stock. From your responses they must not exist for my motor. |
|
| Author: | pokey79 [ Thu Jul 26, 2012 8:02 pm ] |
| Post subject: | Re: 35 vanguard thin head gasket? |
what u think ur going to gain from .003 when u deck heads its around .050????? |
|
| Author: | deadbird8 [ Thu Jul 26, 2012 9:41 pm ] |
| Post subject: | Re: 35 vanguard thin head gasket? |
Copper ones I got were a little thicker, they didn't last- I use the stock ones. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|