| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| 5 HP conversion http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=31587 |
Page 1 of 1 |
| Author: | stretch1985 [ Thu Aug 16, 2012 9:17 pm ] |
| Post subject: | 5 HP conversion |
I am building a mud motor out of a 5 HP snow blower. i am just looking for a good prop to use and a good angle to run my drive shaft for my prop. i am going to use a universal joint to connect the drive shaft to the motor. does anybody have any good ideas on where to start with the angle and prop? |
|
| Author: | stretch1985 [ Sat Aug 18, 2012 5:50 am ] |
| Post subject: | Re: 5 HP conversion |
i have looked at the mud buddy website and they recommend that i use a 6.5x4. i was just wondering if anybody has tried anything else that performs better with a 5 HP motor |
|
| Author: | mud slinger 69 [ Sat Aug 18, 2012 7:18 am ] |
| Post subject: | Re: 5 HP conversion |
Try a 15 degree angle for your frame.Just use the best seals-bearing that ya can on the bottom of your shaft and dont over grease it. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|