| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Exhaust flanges http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=32238 |
Page 1 of 1 |
| Author: | banded-mallard [ Mon Sep 10, 2012 8:00 am ] |
| Post subject: | Exhaust flanges |
Bout to start on my new exhaust and was wondering if that can be bought. I was either going to use the existing ones off the stock muffler or fab some up out of some SS plate. But if I can buy some, even better. |
|
| Author: | Mag10 [ Mon Sep 10, 2012 11:35 am ] |
| Post subject: | Re: Exhaust flanges |
what motor? I have 2-3 sets of 3/16" stainless ones for a 23 briggs. |
|
| Author: | banded-mallard [ Mon Sep 10, 2012 12:03 pm ] |
| Post subject: | Re: Exhaust flanges |
36 prodrive, not sure if the same. My headers are 1.5" mandrel bent tubing. |
|
| Author: | banded-mallard [ Tue Sep 11, 2012 4:39 pm ] |
| Post subject: | Re: Exhaust flanges |
Getting local shop to cut some out, well see how it goes. |
|
| Author: | take'emgator [ Tue Sep 11, 2012 8:57 pm ] |
| Post subject: | Re: Exhaust flanges |
Take your time and weld slowly, it don't take much to warp them |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|