|
|
FAQ
• Login
|
|
It is currently Fri Jul 18, 2025 7:33 am
|
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
banded-mallard
MMT 1000 Club
Joined: Wed Oct 07, 2009 8:18 pm
Posts: 4310
|
 Exhaust flanges Bout to start on my new exhaust and was wondering if that can be bought. I was either going to use the existing ones off the stock muffler or fab some up out of some SS plate. But if I can buy some, even better.
|
| Mon Sep 10, 2012 8:00 am |
|
|
|
Mag10
MMT Pro Member
Joined: Wed Jan 14, 2009 12:31 pm
Posts: 342
Location: Faribault, Mn
|
Re: Exhaust flanges what motor? I have 2-3 sets of 3/16" stainless ones for a 23 briggs.
|
| Mon Sep 10, 2012 11:35 am |
|
|
|
banded-mallard
MMT 1000 Club
Joined: Wed Oct 07, 2009 8:18 pm
Posts: 4310
|
Re: Exhaust flanges 36 prodrive, not sure if the same. My headers are 1.5" mandrel bent tubing.
|
| Mon Sep 10, 2012 12:03 pm |
|
|
|
banded-mallard
MMT 1000 Club
Joined: Wed Oct 07, 2009 8:18 pm
Posts: 4310
|
Re: Exhaust flanges Getting local shop to cut some out, well see how it goes.
|
| Tue Sep 11, 2012 4:39 pm |
|
|
|
take'emgator
MMT Super Elite Member
Joined: Mon Oct 19, 2009 6:38 pm
Posts: 10201
Location: SETX
|
Re: Exhaust flanges Take your time and weld slowly, it don't take much to warp them
|
| Tue Sep 11, 2012 8:57 pm |
|
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 110 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
