MudmotorTalk.com
http://mudmotortalk.com/mmt_v2/

Exhaust
http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=32531		 Page 1 of 1
Author:  FowlMouth251 [ Wed Sep 19, 2012 7:05 pm ]
Post subject:  Exhaust
What's the best way to get the baffles out of stock Briggs exhaust
Author:  Woodiebuster [ Wed Sep 19, 2012 7:09 pm ]
Post subject:  Re: Exhaust
cut it open.
Author:  FowlMouth251 [ Wed Sep 19, 2012 7:19 pm ]
Post subject:  Re: Exhaust
I know that but what's the best way to gut it beat it all out or burn it with a torch
Author:  med [ Wed Sep 19, 2012 7:43 pm ]
Post subject:  Re: Exhaust
I used a hammer, screwdriver, drill with big bit, long needle pliers, the small saw that will hold a hacksaw blade, 6pack of beer, and a truckload of patience. Hope this helps. :lol:
Author:  cb5331 [ Wed Sep 19, 2012 7:49 pm ]
Post subject:  Re: Exhaust
Author:  Bigdeck20 [ Wed Sep 19, 2012 7:50 pm ]
Post subject:  Re: Exhaust
Mine kicked my ass today! Torch made it much easier after beating the hell out of it with a BFH and a driveshaft!
Author:  med [ Thu Sep 20, 2012 5:45 am ]
Post subject:  Re: Exhaust
Author:  deltaduckmaster [ Thu Sep 20, 2012 5:53 am ]
Post subject:  Re: Exhaust
Most the parts are just spot tacked in their. Takes torch cut in pie sections then just bend them down until tack breaks. FYI if you have a dealer around you that deal with the mm if they sell Cdi motors I'm sure they have a hundred busted up exhaust laying around that they will sell you for cheap. Cut ends off dump baffle out and weld back up!!
Author:  gatorkiller1967 [ Thu Sep 20, 2012 7:10 am ]
Post subject:  Re: Exhaust
I used chop saw. Straight even cut. Just twisted the guts till tacks broke
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/