| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Go-Devil HELP!!!! http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=6239 |
Page 1 of 1 |
| Author: | iron man [ Sat Nov 28, 2009 4:35 pm ] |
| Post subject: | Go-Devil HELP!!!! |
I have a 20hp go-devil that runs at full speed when out of the water but bogs down to less than half throttle in the water and it starts backfiring a little after a few minutes of running. what is causing this? need some answers quick. i already brought it to the go-devil place once 2 weeks ago and its not going again unless their work is warrantied. |
|
| Author: | Gigafowl [ Sat Nov 28, 2009 4:41 pm ] |
| Post subject: | Re: Go-Devil HELP!!!! |
Sounds like it is runing on only one cylinder.... Try removing one plug wire at a time while running - bet you get no change when one is removed and engine dies when other one is removed... Cylinder where there is no change is mis-firing or not firing at all... |
|
| Author: | spiderbeaver [ Sun Nov 29, 2009 6:20 pm ] |
| Post subject: | Re: Go-Devil HELP!!!! |
take your carberator apart go to auto zone pick up b12 carberator cleaner in a gallon soke it for a day after soaking spray through all jets and put the carberator back on |
|
| Author: | postalpaul [ Sun Nov 29, 2009 7:34 pm ] |
| Post subject: | Re: Go-Devil HELP!!!! |
Honda I will assume, clean the fuel cut off solenoid on bottom of carb. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|