| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| PVT Arias Piston Specs. http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=68705 |
Page 1 of 1 |
| Author: | riverrat00 [ Sat Oct 22, 2016 1:46 am ] |
| Post subject: | PVT Arias Piston Specs. |
Anyone know what the specs are for the run of the mill Arias piston from PVT. Looking for the compression height and didn't think to measure before I put them in. Stock bore. Trying to calculate CR so I can decide on head decking. |
|
| Author: | dead animal [ Sat Oct 22, 2016 5:25 pm ] |
| Post subject: | Re: PVT Arias Piston Specs. |
use silly-puddy, that's what we would use to check clearance. |
|
| Author: | MaXXis85 [ Mon Oct 24, 2016 5:57 am ] |
| Post subject: | Re: PVT Arias Piston Specs. |
Other than pulling the piston to measure center of wrist pin to top of piston, lets hope someone can help ya. I'm sure if you call Al he will help you out man! |
|
| Author: | riverrat00 [ Mon Oct 24, 2016 9:52 pm ] |
| Post subject: | Re: PVT Arias Piston Specs. |
Al says CR with that combo should be slightly more than 10 to 1 if the heads and gasket are stock. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|