|
|
FAQ
• Login
|
|
It is currently Thu Jun 26, 2025 3:13 pm
|
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
oneneo3
MMT Member
Joined: Tue Jan 20, 2009 2:47 pm
Posts: 42
Location: Kingwood, Tx
|
 PD Clutch slipping Boat was running fine until I hit a big boat wake... then it felt like my engine just jumped out of gear. Now from mid to high throttle it slips and revs out to about 4500... and it feels like it jumps out of gear. got it back on the truck and found a single bent pin under the clutch.
My question is... can I bend that pin back straight or do I need to buy a whole new clutch?
_________________
Git while the gitn's good...
|
| Sun Jan 10, 2010 5:12 pm |
|
|
|
oneneo3
MMT Member
Joined: Tue Jan 20, 2009 2:47 pm
Posts: 42
Location: Kingwood, Tx
|
Re: PD Clutch slipping Just to update. I pulled the motor, dropped the clutch assembly and found 4 of the 6 clutch fingers broken at the inside rivets. Not sure what would cause this. I have 139 hours on the motor. No mods.
_________________
Git while the gitn's good...
|
| Sun Jan 10, 2010 10:19 pm |
|
|
|
JIMMY W
MMT 1000 Club
Joined: Tue Jan 13, 2009 8:02 pm
Posts: 4534
Location: South Louisiana
|
Re: PD Clutch slipping Call Peck at ProDrive 
_________________
17/54 GT EXTREME Center Console, Huntdeck w/ GTR 35
Hoyt Mods and some other goodies
|
| Sun Jan 10, 2010 10:28 pm |
|
|
|
craig
MMT Elite Member
Joined: Tue Jan 13, 2009 7:53 pm
Posts: 7515
Location: Chauvin
|
Re: PD Clutch slipping A new clutch will cost you about 200-250 dollars.
_________________
1750 GatorTail Extreme/Stage 3 37 GTR HD
Procrastination is a lot like masturbation. Sure it sounds great at the time but, in the end your only f--k--g yourself.
|
| Sun Jan 10, 2010 10:33 pm |
|
|
|
oneneo3
MMT Member
Joined: Tue Jan 20, 2009 2:47 pm
Posts: 42
Location: Kingwood, Tx
|
Re: PD Clutch slipping Called Peck and a whole new assembly is $200. Just the armature is like $88 and that probably would fix it but I dont want to risk something else being broken or warped or risk being stranded again so Im replacing the whole thing!!
_________________
Git while the gitn's good...
|
| Mon Jan 11, 2010 10:33 am |
|
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 107 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
