| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| EFI mods question.. http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=70281 |
Page 1 of 1 |
| Author: | Quack N Stack [ Tue Apr 18, 2017 10:14 am ] |
| Post subject: | EFI mods question.. |
Thinking about doing the Level 2 build to my motor this summer, question is can the level 3 be added later on without having to re tune the EFI or does the EFI need to be tuned again once the cam is added? |
|
| Author: | Will C [ Tue Apr 18, 2017 11:19 am ] |
| Post subject: | Re: EFI mods question.. |
When you change the cam its a big difference between tunes. Usally very rich on bottom from weakened vacuum signal and a bit lean on top |
|
| Author: | TPerkins [ Tue Apr 18, 2017 11:26 am ] |
| Post subject: | Re: EFI mods question.. |
Yes, but they hard tune the ecu now. So if down the road you add a cam you would swap your ecu for the lvl3 ecu. Sent from my SM-G930V using Tapatalk |
|
| Author: | Quack N Stack [ Tue Apr 18, 2017 11:37 am ] |
| Post subject: | Re: EFI mods question.. |
So that sounds like just another 400 to spend of the re tune. I guess it would be cheeper in the long run to do straight for the level 3? |
|
| Author: | 3rd Coast Killer [ Tue Apr 18, 2017 12:37 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | Quack N Stack [ Tue Apr 18, 2017 1:07 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | MNwingsetter [ Tue Apr 18, 2017 1:23 pm ] |
| Post subject: | Re: EFI mods question.. |
Unless you did as TP said, then you'd only have to plug in the new ecu right? Sent from my iPhone using Tapatalk |
|
| Author: | Quack N Stack [ Tue Apr 18, 2017 1:34 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | MaXXis85 [ Tue Apr 18, 2017 1:44 pm ] |
| Post subject: | Re: EFI mods question.. |
I can set you up with what you need aswell. I use a fuel controller and you adjust adjust the fuel after you do the cam install. |
|
| Author: | Quack N Stack [ Tue Apr 18, 2017 4:18 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | Glade [ Wed Apr 19, 2017 10:01 am ] |
| Post subject: | Re: EFI mods question.. |
Get a kit from BPS! The tuner has pre-set maps. All you have to do when you go to the next stage is turn a dial to the next map. |
|
| Author: | Will C [ Wed Apr 19, 2017 10:45 am ] |
| Post subject: | Re: EFI mods question.. |
Glade, will the pre set tunes work with non bps parts? |
|
| Author: | Quack N Stack [ Wed Apr 19, 2017 2:23 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | Full Throttle [ Wed Apr 19, 2017 4:54 pm ] |
| Post subject: | Re: EFI mods question.. |
what is involved in installing the tuner? Difficult process or plugnplay? |
|
| Author: | MaXXis85 [ Thu Apr 20, 2017 6:06 am ] |
| Post subject: | Re: EFI mods question.. |
| Author: | Glade [ Thu Apr 20, 2017 1:04 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | Glade [ Thu Apr 20, 2017 1:12 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | MaXXis85 [ Thu Apr 20, 2017 2:56 pm ] |
| Post subject: | Re: EFI mods question.. |
| Author: | Will C [ Thu Apr 20, 2017 4:24 pm ] |
| Post subject: | Re: EFI mods question.. |
Exactly what i was thinking. Correct me please if im wrong but the bps allows 5%+ or - of the base map, level 1 , level 2 etc. i really like tthat a selectable map can get you close to start and then dial in from there. I would be nervous about 5% covering up a 106 lsa or whatever cam / mods. |
|
| Author: | Glade [ Tue Apr 25, 2017 1:22 pm ] |
| Post subject: | Re: EFI mods question.. |
If you are interested in something custom give me a call. I can do anything you want. I can allow more than 5% on the trim pots as well on a custom tuner. 385-695-3807 As far as elevation is concerned, I have found it's a non factor. The MAP sensor makes adjustments for that. I have tested the exact same motor, and tune all the way from below sea level in NOLA, to 8500', and the AFR numbers were negligible. |
|
| Author: | Will C [ Tue Apr 25, 2017 1:47 pm ] |
| Post subject: | Re: EFI mods question.. |
Good deal |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|