No other dots. That would be too easy
| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Cam supplier http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=70343 |
Page 1 of 1 |
| Author: | Will C [ Mon May 01, 2017 8:06 am ] |
| Post subject: | Cam supplier |
i speced out 3 cams ive got here from the same supplier. 2 are 2 teeh off from where they should be and 1 is 1 tooth off from thier timing marks and none are the specs i asked for. Seems no matter how many times i ask for spec cards to come with the cams i dont get those either so i am done with them. Looking to have dyno cams build them now. Are yall getting what u ask for from them with spec cards? |
|
| Author: | MNwingsetter [ Mon May 01, 2017 9:18 am ] |
| Post subject: | Re: Cam supplier |
Care to make a PSA and disclose the suppliers name? Sent from my iPhone using Tapatalk |
|
| Author: | Will C [ Mon May 01, 2017 9:29 am ] |
| Post subject: | Re: Cam supplier |
No sir im not going there, just looking to move forward |
|
| Author: | MaXXis85 [ Mon May 01, 2017 10:04 am ] |
| Post subject: | Re: Cam supplier |
well the cam gear has 70 teeth. and each tooth 5.14 Degrees. The cam makes 1/2 revolution per crank Revoluion so to make a full cycle we have 720 degrees of crankshaft operation in a camshaft event.... So in essence one tooth off is 10.28 degrees wrong.. That's a big deal man. You have slack and cam walk that can alter your specs a little....but that's bad. |
|
| Author: | Will C [ Mon May 01, 2017 10:26 am ] |
| Post subject: | Re: Cam supplier |
Yea the dots being off isnt the end of the world if u check it. But even setting them where they would work is still not what i ordered. Sooo is dyno cams getting a thumbs up? |
|
| Author: | MaXXis85 [ Mon May 01, 2017 10:46 am ] |
| Post subject: | Re: Cam supplier |
| Author: | Will C [ Mon May 01, 2017 11:23 am ] |
| Post subject: | Re: Cam supplier |
No other dots. That would be too easy
|
|
| Author: | MaXXis85 [ Mon May 01, 2017 12:22 pm ] |
| Post subject: | Re: Cam supplier |
| Author: | Will C [ Mon May 15, 2017 9:00 pm ] |
| Post subject: | Re: Cam supplier |
Just want to give a thumbs up to Dyno. They built exactly what i asked for down to the exact degree. Happy customer
|
|
| Author: | MaXXis85 [ Tue May 16, 2017 5:37 am ] |
| Post subject: | Re: Cam supplier |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|