MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
Making shroud/cover for dual Mikuni carbs on MB http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=72505 |
Page 1 of 1 |
Author: | Survivor [ Sat May 26, 2018 1:24 pm ] |
Post subject: | Making shroud/cover for dual Mikuni carbs on MB |
Just bought a use Mud Buddy, has the dual carbs sticking out in the open, and I DON"T like it. Plan to make some adjustments here. Anyone made any covers or such for protection and prevention of the elements? This scares me in a storm or an overaggressive limb wiping the whole thing out. |
Author: | brycecheramie [ Fri Jun 01, 2018 6:39 am ] |
Post subject: | Re: Making shroud/cover for dual Mikuni carbs on MB |
Author: | bayouboy [ Sat Jun 02, 2018 10:12 pm ] |
Post subject: | Re: Making shroud/cover for dual Mikuni carbs on MB |
Yeah they look cool, but not a whole lot you can do to protect them. Ehh, unless you install some chiksan joints. Then you could damn near put the carbs in your pockets. lol |
Author: | SCmudder7071 [ Sun Jun 03, 2018 6:28 am ] |
Post subject: | Re: Making shroud/cover for dual Mikuni carbs on MB |
I want to say BoarDR made some covers for them last one time similar to the single carb setup he makes. That would be your best bet. |
Author: | 50fps [ Mon Jun 04, 2018 12:51 pm ] |
Post subject: | Re: Making shroud/cover for dual Mikuni carbs on MB |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |