|
FAQ
• Login
|
|
It is currently Thu Mar 28, 2024 6:21 pm
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Author |
Message |
SChms
MMT Member
Joined: Sun Jul 08, 2018 7:44 pm Posts: 23 Location: South Carolina
|
35 Vanguard Governor
I just got a new engine with a 2018 block on a older frame so I’m still setting it up. I’m trying to get the rpms to around 3900 or 4K by adjusting the governor out some. But as you can see it’s pretty much out all the way so I was wondering how to get those last few rpms up. Just keep screwing it out more? Right now it’s running around 3400-3500 out of the water
Sent from my iPhone using Tapatalk
|
Tue Sep 11, 2018 7:48 am |
|
|
Will C
MMT Sponsor
Joined: Fri Jan 10, 2014 1:16 pm Posts: 2107 Location: Gladewater TX
|
Re: 35 Vanguard Governor
Back that screw back off some or it can fall out of place. Replacing that green spring would be the white way.... put a zip tie through the gov spring and let the coils catch the rpms at 4350
|
Tue Sep 11, 2018 8:23 am |
|
|
Will C
MMT Sponsor
Joined: Fri Jan 10, 2014 1:16 pm Posts: 2107 Location: Gladewater TX
|
Re: 35 Vanguard Governor
U could also try just moving gov spring to the slot # 3
|
Tue Sep 11, 2018 8:26 am |
|
|
SChms
MMT Member
Joined: Sun Jul 08, 2018 7:44 pm Posts: 23 Location: South Carolina
|
Re: 35 Vanguard Governor
What do you mean put a zip tie through the gov spring?
Sent from my iPhone using Tapatalk
|
Tue Sep 11, 2018 8:47 am |
|
|
MaXXis85
MMT Elite Member
Joined: Wed Jan 14, 2009 7:23 am Posts: 6233 Location: Tarkington, TX
|
Re: 35 Vanguard Governor
_________________ Bayou Surface Drive 337-351-0362 Tarkington, TX 77327
|
Tue Sep 11, 2018 9:31 am |
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 265 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|