| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Magneto and PTO Bearing http://mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=73225 |
Page 1 of 1 |
| Author: | afterelk [ Wed Nov 14, 2018 11:42 am ] |
| Post subject: | Magneto and PTO Bearing |
Anyone here ever changed out the magneto and/or PTO bearings on a Vanguard 35 Non CDI? Have a motor that I'm thinking about rebuilding and debating on whether or not to try to do a bearing swap while I have it apart. Haven't measured out the wear on current bearings yet cause still running the boat hunting. Heard the PTO doesn't really change out and you have to buy a new cover or find someones old cracked cover and remove bearing. Not sure how bad the magneto bearing is either. Looking for any useful advice. Thanks. |
|
| Author: | Will C [ Sat Nov 17, 2018 12:35 am ] |
| Post subject: | Re: Magneto and PTO Bearing |
Usually the flywheel side will look pretty good even on some oldies. Not sure if the bearing is even avail anymore. When it was available it was 200$ ish. If you need a rear set then just grab a cover. Briggs used to even have a service tool set for them. I've used my cam bearing tool for big motors and worked good. These days I just buy new parts as needed |
|
| Author: | afterelk [ Mon Nov 19, 2018 8:51 am ] |
| Post subject: | Re: Magneto and PTO Bearing |
Thanks Will C. |
|
| Author: | MaXXis85 [ Mon Nov 19, 2018 3:48 pm ] |
| Post subject: | Re: Magneto and PTO Bearing |
Front bearing is available for about $250 plus labor to swap it. |
|
| Author: | afterelk [ Sat Nov 24, 2018 12:18 am ] |
| Post subject: | Re: Magneto and PTO Bearing |
Thanks Maxxis85 |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|