oh Lord, not another chine thread!
just read through this...
viewtopic.php?f=4&t=11972
| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Please Chine in.... http://mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=12222 |
Page 1 of 1 |
| Author: | lizard55033 [ Tue Sep 07, 2010 1:06 pm ] |
| Post subject: | Please Chine in.... |
As I learn more and more about these rigs I find more and more technical questions. As far as the Chine setup goes; how is the ride and performance affected by chine design? Rounded? Square? Tappered? What did I miss? |
|
| Author: | SmokeEater829 [ Tue Sep 07, 2010 1:12 pm ] |
| Post subject: | Re: Please Chine in.... |
Round- slower, turns better Square- a little faster, carries a load better, slides when turning Tapered- I have no experience with them, but I'll guess it's a mixture of the 2 |
|
| Author: | Josh [ Tue Sep 07, 2010 1:20 pm ] |
| Post subject: | Re: Please Chine in.... |
oh Lord, not another chine thread! just read through this... viewtopic.php?f=4&t=11972 |
|
| Author: | quackconsumer [ Wed Sep 08, 2010 11:08 am ] |
| Post subject: | Re: Please Chine in.... |
From what I've seen da best overall is da steped chine. But what do I know. |
|
| Author: | shallow water master [ Wed Sep 08, 2010 1:16 pm ] |
| Post subject: | Re: Please Chine in.... |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|