| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| 1654 with 35 http://mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=22813 |
Page 1 of 1 |
| Author: | cordgrass [ Tue Oct 04, 2011 6:23 pm ] |
| Post subject: | 1654 with 35 |
Had 35 hp gator-tail short installled today. I am running a 1654 gator-tail boat short trans. went test it out running 27.7-28.3 depth water just me light load. does this sound about right? |
|
| Author: | deltaduckmaster [ Tue Oct 04, 2011 6:30 pm ] |
| Post subject: | 1654 with 35 |
| Author: | cordgrass [ Tue Oct 04, 2011 7:39 pm ] |
| Post subject: | 1654 with 35 |
It's set in the middle hole. I need to do a little skeg adjustment pulling to the left. |
|
| Author: | deltaduckmaster [ Tue Oct 04, 2011 8:26 pm ] |
| Post subject: | 1654 with 35 |
I know some guys with stage 1 running 35 in that same size boat !! |
|
| Author: | T-Bubba [ Tue Oct 04, 2011 8:32 pm ] |
| Post subject: | Re: 1654 with 35 |
isnt that the same size hull Tyler has... his boat runs damn good |
|
| Author: | deltaduckmaster [ Tue Oct 04, 2011 8:33 pm ] |
| Post subject: | 1654 with 35 |
| Author: | cordgrass [ Wed Oct 05, 2011 12:51 pm ] |
| Post subject: | 1654 with 35 |
Went run it today for lunch with 2 people 210 & 240 lbs got the same speeds |
|
| Author: | deltaduckmaster [ Wed Oct 05, 2011 2:34 pm ] |
| Post subject: | 1654 with 35 |
One thing I found over the years are Sd mm are more sensitive to wAter condition wind and current! Maybe I just never noticed it in outboards but do I'm my gt!! You might run one place and hit 28 then turn a corner and run 31 !! |
|
| Author: | WestEndAngler [ Wed Oct 05, 2011 2:54 pm ] |
| Post subject: | Re: 1654 with 35 |
Before adjusting skeg make sure the boat is 100% balanced. I run my motor in the top hole. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|