I got an 1860 and It slides pretty good. If this thing got away from me in deep water do you think it would possibly overturn?? Or do you think that it would just slide? It almost got away from me when I was doing about 30 in deep water last week and I think I shot crap clear to my socks... Just wondering if it was possible to dig in and flip or if it would just slide? I'm sure someone here knows.

You can slide, then catch an edge. The momentum & weight of boat will cause a side to dip thus either throwing you out or allowing a wall of water to flood over the starboard or port side. I've seen boats sink doing tricks like this. Only do 360's or slides/ spins in shallow water

X2 ^^itll even happen in a smaller boat my buddy has a 16x42 an we got to sliding and started hoping then the side caught and tossed our buddy out like a rag doll

I was hoping you would reply since we got the same boat.

I just got my motor back together finally one year after the accident..

BPS CAM
MM EXHAUST
MIKUNI
SS MANLEY VALVES
HEADS DECKED
ROLLER ROCKERS
PORTED
INTAKE WORK
BILLET PUSH TUBES
BPS CONNECTING RODS
PISTONS SHAVED
5200 REV LIMITER
Lots of other small stuff to help air flow.

Running 100 AV GAS and what a difference that makes...CLEAN CARB AND FILTER!! No Orange gas for me!

And I live the smell of it coming out the exhaust! lol

Fucker Runs... Haven't had it over 4000 RPM Yet. Got 5 hours on it. Getting ready to let her buck this weekend.

My buddy flipped his skiff in sandy cove with a 25 merc by turning to sharp in shallow water, it pretty damn funny, but yet scary lol

Will def catch and throw your a$$ out. Threw my friend out the other week luckly I had a grab bar. But I still bent that to shit. Just be careful and respect the boat cause it def can f you up.