| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Another boat paint question http://mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=3730 |
Page 1 of 1 |
| Author: | brassass [ Thu Aug 06, 2009 6:23 am ] |
| Post subject: | Another boat paint question |
figured i would slap a coat of paint on the rig to fit in with everyone else. My question is not the prep work but what kind of spray do you guys use? I am asking because i got my hands on one of those nice sprayers to stain my fence and deck, and says it will spray some paint good too. However i haven't used it yet and wanted to get some opinions first. So what kind of sprayers to you guys use if you use any at all? Would rather not use 50-11 spray cans for my boat |
|
| Author: | SwampSnyper [ Thu Aug 06, 2009 7:00 am ] |
| Post subject: | Re: Another boat paint question |
Any sprayer will work. Just gonna have to play with the thinning ratio's and air mixture. |
|
| Author: | brassass [ Thu Aug 06, 2009 7:44 am ] |
| Post subject: | Re: Another boat paint question |
even one of those electric type sprayers? Hope so really can't get a bigger air compressor at the moment, my little one won't handle a sprayer. |
|
| Author: | SwampSnyper [ Thu Aug 06, 2009 7:57 am ] |
| Post subject: | Re: Another boat paint question |
I would think. Mix it thin and apply a few coats. Spay it on something else 1st to sample it. |
|
| Author: | UNCLE-J [ Thu Aug 06, 2009 8:09 am ] |
| Post subject: | Re: Another boat paint question |
I painted my boat with a Roller and Paint Brush. The only prep work was spraying it down with Alum. Bright. The Type of Paid is a Duralux Duck Boat Green. It is for Alum. Step One Bring ya boat to car wash and clean it. The degreaser works good first Step Two Spray the shit out of your boat with Alum. Bright.. This will etch the Alum Let this sit for about 5 minutes Step three spray boat down with water hose Step four once boat is dry.. Painted it up... the paint cost about $35 gallon. I used less than a gallon. * The paint job you see in my picture is over three months old.. I abuse the sht out of it, and it holds up.. |
|
| Author: | UNCLE-J [ Thu Aug 06, 2009 11:23 am ] |
| Post subject: | Re: Another boat paint question |
Brassass, I was found some more detailed information for you. See Below: Shannons Hardware Stocks this paint in Houma, la and Morgan City, la. http://www.duraluxpaint.com/ DURALUX MARINE ALUMINUM BOAT PAINT A vinyl-type coating for aluminum and galvanized surfaces. ALUMINUM BOAT PAINT has excellent adhesion that eliminates the need for a primer, thereby cutting time and labor costs in half. ALUMINUM BOAT PAINT washes easily and resists oil, gasoline and discoloration from harbor gases. |
|
| Author: | UNCLE-J [ Tue Aug 11, 2009 5:13 pm ] |
| Post subject: | Re: Another boat paint question |
When you paint the floor, and deck of your boat, be sure to mix some grip into your paint. It only cost around $4.00 for the container. It has a orange lid, and white pale. Make sure to mix it good into your paint... Then just roll it on like you would any other paint.. GOOD LUCK. * I did this after painting the whole boat. So, I have two coats on floor and decks. |
|
| Author: | schrieverboy [ Tue Aug 11, 2009 6:14 pm ] |
| Post subject: | Re: Another boat paint question |
duralux is da pooop... sprayed it on ma boat and it holding up exteremly well..used there spray paint too fa ma stencils and it came out good |
|
| Author: | LA OUTLAW [ Tue Aug 11, 2009 6:19 pm ] |
| Post subject: | Re: Another boat paint question |
| Author: | schrieverboy [ Tue Aug 11, 2009 6:25 pm ] |
| Post subject: | Re: Another boat paint question |
i tried to already but it denied ma pics cause of some hdr format or some sh!t.... as soon as i figure it out ill post some.. |
|
| Author: | LA OUTLAW [ Tue Aug 11, 2009 10:13 pm ] |
| Post subject: | Re: Another boat paint question |
Posting pictures is childsplay....Get a photobucket account, upload all of your pictures into it. Then when ever your ready to post a picture on MMT copy the IMG Code at the bottom of the picture you want to post and paste it in the subject body of your message..ITS THAT SIMPLE!!   Oh and when you do it this way you dont have pictures so small you cant see them...
|
|
| Author: | brassass [ Wed Aug 12, 2009 6:35 am ] |
| Post subject: | Re: Another boat paint question |
| Author: | UNCLE-J [ Wed Aug 12, 2009 8:20 pm ] |
| Post subject: | Re: Another boat paint question |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|