|
FAQ
• Login
|
|
It is currently Fri Mar 29, 2024 9:21 am
|
|
Page 1 of 1
|
[ 9 posts ] |
|
Putting a larger motor on a Go Devil Boat??
Author |
Message |
jawshunting
MMT Member
Joined: Sun Jan 13, 2013 8:00 am Posts: 27
|
Putting a larger motor on a Go Devil Boat??
I have a 1644 Go Devil boat. The boat is rated for a 30 hp. I have a 23 long tail on the boat now. I want to convert to a surface drive. Does anyone have experience with running a 35 hp. on this boat. I think the performance will be what I am looking for. However, I am kind of scared about getting water over the transom when I stop, because of the added weight of the motor. Any help would be appreciated. I also have my eye on a 27 hp Mud Buddy surface drive, but don't want be disappointed with performance of that hp.
|
Sun Oct 15, 2017 1:02 pm |
|
|
Russ
MMT 1000 Club
Joined: Mon Dec 31, 2012 11:07 pm Posts: 4820 Location: West Monroe, LA
|
Re: Putting a larger motor on a Go Devil Boat??
just blip the throttle before the wave gets to the transom, all good. don't over think it
#CFFITR #TheGhostBoat #whoneedsphysicsihaveamudmotor
|
Sun Oct 15, 2017 2:13 pm |
|
|
tystorm
MMT Member
Joined: Sun Sep 20, 2015 7:15 pm Posts: 41
|
Re: Putting a larger motor on a Go Devil Boat??
i have that exact setup. had a 24 longtail on a lowe and sold it to buy a 35 gdsd. then sold the lowe when i found a 1644 go devil hull. its a great small water boat. the weight does make it ride a bit lower than i like in the rear but as said above just dont stop suddenly and it shouldnt be a problem. i added by auto bilge just in case but i dont think it has ever ran. i am thinking about adding spray rails to the sides to help give it a bit more lifton plane. but solo ive had it touch 30mph with a light load. average with 2 guys and heavy hunt load is 24-25. i like it cuz its light and i can run the whole thing up on shore and still push off if need be by myself. i have my gas tank mounted mid ship nad the battery right behind it, about 3-4ft from the transom. motor is a short transom on short transom hull.
|
Sun Oct 15, 2017 4:53 pm |
|
|
brycecheramie
MMT 1000 Club
Joined: Thu Nov 04, 2010 7:38 am Posts: 4323 Location: Cut Off, La.
|
Re: Putting a larger motor on a Go Devil Boat??
X's 2^^
I ran a big block prodrive on a 15x44. and the prodrive is heavier than GDSD. Did well, just be careful when slowing down, like mentioned above.
_________________ Refurbishing a Prodrive
|
Sun Oct 15, 2017 4:58 pm |
|
|
jawshunting
MMT Member
Joined: Sun Jan 13, 2013 8:00 am Posts: 27
|
Re: Putting a larger motor on a Go Devil Boat??
I ended up buying a 37 EFI GatorTail. GatorTail said it weighs 270 pounds. I have not mounted it on the boat yet, but I am kind of intimidated. That is one big motor. I hope my 1644 will hold it. Time will tell.
|
Thu Oct 19, 2017 7:15 pm |
|
|
brycecheramie
MMT 1000 Club
Joined: Thu Nov 04, 2010 7:38 am Posts: 4323 Location: Cut Off, La.
|
Re: Putting a larger motor on a Go Devil Boat??
_________________ Refurbishing a Prodrive
|
Thu Oct 19, 2017 7:56 pm |
|
|
brycecheramie
MMT 1000 Club
Joined: Thu Nov 04, 2010 7:38 am Posts: 4323 Location: Cut Off, La.
|
Re: Putting a larger motor on a Go Devil Boat??
And if you’re intimidated by a GTR, wait till you run a PD!
_________________ Refurbishing a Prodrive
|
Thu Oct 19, 2017 7:57 pm |
|
|
jawshunting
MMT Member
Joined: Sun Jan 13, 2013 8:00 am Posts: 27
|
Re: Putting a larger motor on a Go Devil Boat??
Thanks
|
Thu Oct 19, 2017 9:01 pm |
|
|
jcalla4
MMT Member
Joined: Mon Jul 17, 2017 2:11 pm Posts: 10 Location: Thibodaux, LA
|
Re: Putting a larger motor on a Go Devil Boat??
I have the exact same setup but with a 35 GTR. Set it up a few months ago. Runs great the only problem i have is a bit of a porpoising issue when cruising full speed with just me in the boat. I'm in the process of installing some wedges to help out that issue. boat runs about 23-24 with a good amount of weight in it (2 guys, ice chest, dog, blind materials, etc.). If these wedges work out, i think I'll be able to get up to around 27-28 with just me.
|
Fri Oct 20, 2017 7:31 am |
|
|
|
|
Page 1 of 1
|
[ 9 posts ] |
|
Who is online |
Users browsing this forum: Google [Bot] and 178 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|