MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
27 gd surface drive on 15/46 weldbilt flat http://mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=71937 |
Page 1 of 1 |
Author: | Cbossier [ Sun Jan 21, 2018 12:28 pm ] |
Post subject: | 27 gd surface drive on 15/46 weldbilt flat |
Recently bought this boat and I don’t think I’m getting the right speed from it I hit 20 with 2 people and 15 with a hunt load and 3 people My boat doesn’t throw a rooster tail when my handle is in the float position my trim knob is trimmed up all the way what can I do to get more speed out of this boat? New prop? |
Author: | cjf [ Mon Jan 22, 2018 11:54 am ] |
Post subject: | Re: 27 gd surface drive on 15/46 weldbilt flat |
Have a 27 gdsd on a 15/42 alweld . With a brand new prop it doesn’t throw much of a rooster tail at all. The more I wore the prop down the more it would throw . IMO on my boat I don’t wana see much of a rooster tail. As for as speed goes check what rpm your turning up with 2 guy and a hunting load mines will run 3550 range 25mph. Also move shit around in your boat and see if that helps. I put as much as I can all the way to the front. Definitely by my self. Which I don’t weigh much. The more weight I have up front the better it runs . |
Author: | Russ [ Mon Jan 22, 2018 1:12 pm ] |
Post subject: | Re: 27 gd surface drive on 15/46 weldbilt flat |
That's not a whole lot of boat for that kind of load. The speeds seem a little low, but you're in the ballpark with a 3man load and gear. #CFFITR #TheGhostBoat #whoneedsphysicsihaveamudmotor |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |