| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Prodrive Gen 2 Skeg http://mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=72594 |
Page 1 of 1 |
| Author: | Wilson [ Tue Jun 19, 2018 2:21 pm ] |
| Post subject: | Prodrive Gen 2 Skeg |
Does anyone know if the new PD skegs (like the ones Bayouboy use to make) will fit on a Gen 2 lower unit? |
|
| Author: | BlueShamu [ Tue Jun 19, 2018 2:22 pm ] |
| Post subject: | Prodrive Gen 2 Skeg |
Yes, I know. No, they don't. (At least, if you are asking if the Gen III and Gen IV LU skegs fit the Gen II.) |
|
| Author: | Wilson [ Tue Jun 19, 2018 2:44 pm ] |
| Post subject: | Re: Prodrive Gen 2 Skeg |
Basically I want to get a Bayouboy skeg for my Gen 2, but since he doesn't make them anymore I was hoping the new PD skegs without the bar at the bottom would work. Sounds like I'm SOL. Thanks for the info. |
|
| Author: | brycecheramie [ Tue Jun 19, 2018 3:52 pm ] |
| Post subject: | Re: Prodrive Gen 2 Skeg |
| Author: | Wilson [ Mon Jun 25, 2018 5:29 pm ] |
| Post subject: | Re: Prodrive Gen 2 Skeg |
Are they made out of 1/4" 5086 aluminum? |
|
| Author: | BlueShamu [ Mon Jun 25, 2018 8:54 pm ] |
| Post subject: | Re: Prodrive Gen 2 Skeg |
If I recall correctly, yes....1/4" thick aluminum. A carbide, metal cutting circular saw blade, reciprocating saw and drill....and a good template! |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|