I wish someone did that stuff up North here!
| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| UHMW some slick stuff http://mudmotortalk.com/mmt_v2/viewtopic.php?f=5&t=1966 |
Page 1 of 1 |
| Author: | SPRIG [ Thu May 07, 2009 3:42 pm ] |
| Post subject: | UHMW some slick stuff |
Just had uhmw put on my boat and the first thinig I was told was NOT to unhook it before launching on a steep ramp. And I didn"t. My problem came when I went to load her back up. Lined her up just like I always have and gave her a little gas to run her up on the trailer. Caution, idle up on the trailer. I never slowed down until I hit the bow mount. If it goes over stumps like it goes over runners, shouldn't feel half of them. ________________________________________________________ All it takes for evil to prevail is for good men to do nothing! 18X54gtb 35gtr |
|
| Author: | Mitschke [ Thu May 07, 2009 5:57 pm ] |
| Post subject: | Re: UHMW some slick stuff |
Glad you like it. I know i like mine. I have to wait till my boat is in the water to unhook it. Or else.. LOL I try to beach my boat.... and it slides off. |
|
| Author: | Larry D [ Sat May 09, 2009 7:08 pm ] |
| Post subject: | Re: UHMW some slick stuff |
I wish someone did that stuff up North here!
|
|
| Author: | robicheaux [ Tue May 19, 2009 5:11 pm ] |
| Post subject: | Re: UHMW some slick stuff |
what is uhmw? |
|
| Author: | TexasProud [ Tue May 19, 2009 5:21 pm ] |
| Post subject: | Re: UHMW some slick stuff |
about $1500 poly bottom kinda like an airboat but thinner and glued on |
|
| Author: | Full Throttle [ Tue May 19, 2009 6:37 pm ] |
| Post subject: | Re: UHMW some slick stuff |
| Author: | Mitschke [ Tue May 19, 2009 8:49 pm ] |
| Post subject: | Re: UHMW some slick stuff |
Da stuff in the classifieds is to thick... Unless you wanna bolt it to your hull. Wipe it down with acetone, sand it.... and sand it... sand it a little more...... and maybe a little more, wipe it with acetone, lay the epoxy, lay the polymer, apply the tape, apply the foam, apply the bag over the boat and fasten to tape, hook up vaccum generators, and let er rip.... Whole process took me about 5 hours... |
|
| Author: | Full Throttle [ Wed May 20, 2009 11:14 am ] |
| Post subject: | Re: UHMW some slick stuff |
| Author: | Mitschke [ Wed May 20, 2009 9:08 pm ] |
| Post subject: | Re: UHMW some slick stuff |
There is one kit, and i doubt they will sell it to you. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|