| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Boat size http://mudmotortalk.com/mmt_v2/viewtopic.php?f=5&t=37414 |
Page 1 of 1 |
| Author: | nboone20 [ Sat Feb 09, 2013 3:42 pm ] |
| Post subject: | Boat size |
What is the fastest size hull for a 35. Id like to have 54 in wide |
|
| Author: | msm8281 [ Sat Feb 09, 2013 6:01 pm ] |
| Post subject: | Re: Boat size |
18x46 or 17x46 |
|
| Author: | T-Bubba [ Sun Feb 10, 2013 7:20 am ] |
| Post subject: | Re: Boat size |
one of the guys that works for GT has i think a 16x54... its fast |
|
| Author: | Team Camo [ Sun Feb 10, 2013 7:23 am ] |
| Post subject: | Re: Boat size |
16/60 square chine |
|
| Author: | nboone20 [ Mon Feb 11, 2013 6:04 am ] |
| Post subject: | Re: Boat size |
Can somone explain what the differemt chines do |
|
| Author: | T-Bubba [ Mon Feb 11, 2013 6:36 am ] |
| Post subject: | Re: Boat size |
| Author: | Team Camo [ Mon Feb 11, 2013 6:59 am ] |
| Post subject: | Re: Boat size |
| Author: | SmokeEater829 [ Mon Feb 11, 2013 7:26 am ] |
| Post subject: | Re: Boat size |
Square chines- draft less,carry a load better, prone to sliding. Sliding is more evident with minimal tiller time. Round chines- draft more but turn much better at speeds Tapered chine- a combination of the two. I think that sorta sums it up |
|
| Author: | nboone20 [ Mon Feb 11, 2013 10:27 am ] |
| Post subject: | Re: Boat size |
What is the best chine to have |
|
| Author: | GSUrugger [ Mon Feb 11, 2013 12:21 pm ] |
| Post subject: | Re: Boat size |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|