| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| 18 x 48 Uncle J with 36 PD http://mudmotortalk.com/mmt_v2/viewtopic.php?f=5&t=39019 |
Page 1 of 1 |
| Author: | duckduckboom [ Sun Mar 24, 2013 1:39 pm ] |
| Post subject: | 18 x 48 Uncle J with 36 PD |
All 1/8th 18 foot long 4 foot wide 18 inch sides Square chine 2009 Stock 36 PD(for now) Deep water +/- 27mph average me (190#) normally with 2 batteries and ice chest Shallow water +/-29mph with the same load Deep water 20 mph- 5 guys (190# 180# !80# 200# 210#) bowfishing equipment, 3 batteries, two 6 foot alligator gar, 25 redfish, 120 and 70 quart ice chest Shallow water same load 22 mph Over all I really like my boat. I like boats that are wide open. I have had it for almost 2 years now and have put 500 hours on the motor during that time. The only changes i would make to my boat is loose the sport deck, get 20" inch sides, and make it 6 inches wider. The reason i would lose my sport deck is just because i like the look of a flat transom more. Reasoning for 20 inch sides is it gets hairy sometimes when you run up on a stump or everyone runs to one side to shoot a fish. I would rather the 54" inch wide bottom because a lot of my time is spent frogging and bowfishing in the marsh. I would do it mainly for stability reasons. I do hunt flooded timber from time to time but we drive the boat close and walk in so width is not an issue for me. |
|
| Author: | duckduckboom [ Sun Mar 24, 2013 1:41 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
| Author: | duckduckboom [ Sun Mar 24, 2013 1:44 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
| Author: | Tenpoint [ Sun Mar 24, 2013 1:50 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
Nice!! I remember building that one. Quick and easy, the way I like em. Lol. |
|
| Author: | CootSlayerRMFT [ Sun Mar 24, 2013 1:52 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
Great boat, why would you wanna sell it? |
|
| Author: | duckduckboom [ Sun Mar 24, 2013 1:55 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
Its a review not a classified lol. Oh and another thing about this boat is it can dump fellow MMT members over the front at 2 mph |
|
| Author: | dfou [ Sun Mar 24, 2013 2:42 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
What lights you using for bowfishing? |
|
| Author: | duckduckboom [ Sun Mar 24, 2013 2:44 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
8- 27 watt led's from from customfitz.com wired 24 volt and tinted yellow |
|
| Author: | deltaduckmaster [ Sun Mar 24, 2013 2:49 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
| Author: | duckduckboom [ Sun Mar 24, 2013 3:06 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
lol |
|
| Author: | CootSlayerRMFT [ Sun Mar 24, 2013 3:45 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
| Author: | dfou [ Sun Mar 24, 2013 4:28 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
| Author: | Will [ Sun Mar 24, 2013 4:36 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
Prodrive |
|
| Author: | duckduckboom [ Sun Mar 24, 2013 4:58 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
| Author: | dfou [ Sun Mar 24, 2013 5:21 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
| Author: | duckduckboom [ Sun Mar 24, 2013 5:27 pm ] |
| Post subject: | Re: 18 x 48 Uncle J with 36 PD |
Two deep cycle wired in series. I just recently switched to 24 volt. I shot over them for 6 hours and they didn't dim |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|