| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| Boat speeds http://mudmotortalk.com/mmt_v2/viewtopic.php?f=5&t=41192 |
Page 1 of 1 |
| Author: | Muddrunner958 [ Wed May 29, 2013 9:57 am ] |
| Post subject: | Boat speeds |
My buddy is running a 1438 with mudbuddy 23 What speeds should he be gating out of it? |
|
| Author: | CCC [ Wed May 29, 2013 10:06 am ] |
| Post subject: | Re: Boat speeds |
It's should fly with 1 person if its not plowing too bad |
|
| Author: | tailfisher17t [ Wed May 29, 2013 12:34 pm ] |
| Post subject: | Re: Boat speeds |
Yup cause it will sink to da bottom! |
|
| Author: | tailfisher17t [ Wed May 29, 2013 12:40 pm ] |
| Post subject: | Re: Boat speeds |
Kinda like sex with your best friends girl! |
|
| Author: | Muddrunner958 [ Wed May 29, 2013 1:36 pm ] |
| Post subject: | Re: Boat speeds |
Iol and yea I have that problem with my boat Can't slow down fast or I get bout 2 foot of water in boat |
|
| Author: | Muddrunner958 [ Wed May 29, 2013 3:53 pm ] |
| Post subject: | Re: Boat speeds |
Gotcha |
|
| Author: | rudyeng [ Wed May 29, 2013 5:36 pm ] |
| Post subject: | Re: Boat speeds |
I had a 1442 w/ 23 Dixie. To remedy the water over transom & CG issues I added homemade trim tabs. In my case it worked great. You could stop at WOT. No water issues. Used scrap stainless my welder had. Bent it 90 degrees. Measured 10" wide x 6" long (both sides) Hope that helps. |
|
| Author: | Muddrunner958 [ Thu May 30, 2013 5:32 pm ] |
| Post subject: | Re: Boat speeds |
Did u get more speed with the tabs on? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|