Need a little help here.....
Looking for info on how to disable the leveling sensor for starting a mudbuddy longtail..I've got the wiring diagram but do not see it listed in the schematic..
What am I missing here??????

i wouldnt disconnect that if i was u but thas my own opinion

i had a 27 kohler gdlt, i was havin problems with that mercury leveler falling off, the screw kept commin out, i got a new bolt, and turned it vertical so that it would start in any position, didnt have to take it off.

Why don't you disconnest the safety kill switch too? That way, when that thing starts up at about 1/2 throttle and throws you out of the boat, it can spin around and .........

Ever see anyone run over by a boat? Those stainless steel props make nice, evenly spaced gashes from your neck down to your feet.

I'm 30 years Fire - Rescue on the Gulf Coast and have seen SEVERAL!

Leave the damm safety devices alone! The motor builders put them there for a reason!

Sheeeeeesh!

Really appreciate the helpful insight here...
This is not one of the redneck moments that goes something like this...

Hey Bubba...hold my beer and watch this.....

I'm working with an older jonboat (16" transom) that requires me to practically touch my toes to get the damn motor level enough to start it.

I figured it out....process of elimination by following the wires off the starter. Ya'll have a great season.