| MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
| First long tail mud motor http://mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=31556 |
Page 1 of 1 |
| Author: | duck assassin [ Wed Aug 15, 2012 10:15 pm ] |
| Post subject: | First long tail mud motor |
I just bought a go devil 25 koholer long tail and the first time I took it out the motor pushes the handle right to the floor almost when I power it up I did measure the prop and it was wore bad so I ordered a new one is this the cause of that or is there something else wrong any help would be much ap. |
|
| Author: | Woodiebuster [ Wed Aug 15, 2012 10:19 pm ] |
| Post subject: | Re: First long tail mud motor |
Adjust it using the tab on the cav. plate. |
|
| Author: | duck assassin [ Wed Aug 15, 2012 10:34 pm ] |
| Post subject: | Re: First long tail mud motor |
is that the plate above the prop |
|
| Author: | Woodiebuster [ Wed Aug 15, 2012 10:46 pm ] |
| Post subject: | Re: First long tail mud motor |
Yep, when you get your new prop bend the tab on the end up 1/8" at a time until it rides just below the surface of the water. |
|
| Author: | duck assassin [ Wed Aug 15, 2012 11:29 pm ] |
| Post subject: | Re: First long tail mud motor |
ok thanks much |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|