MudmotorTalk.com http://mudmotortalk.com/mmt_v2/ |
|
SLT prop torque http://mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=71659 |
Page 1 of 1 |
Author: | Fox River Killer [ Sat Dec 02, 2017 8:26 am ] |
Post subject: | SLT prop torque |
Im trying to figure out what to torque this prop at on my mudbuddy slt. It is a hex prop and when I took it off it had some play in it like the Teflon nut wasn't snugged up. Is this correct or should it be toqued down? Thanks |
Author: | CypressCritter [ Sat Dec 02, 2017 9:26 am ] |
Post subject: | Re: SLT prop torque |
There should be no slack, IMO, or you will get Prop "slap" when not in water. |
Author: | Fox River Killer [ Sat Dec 02, 2017 9:32 am ] |
Post subject: | Re: SLT prop torque |
I know on the thread on style prop that some allowable slack is necessary but with this hex style prop as you said I wouldn't think slack would be needed too. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |