Jus ordered my new rig and gettin a stage 1 with a crossover so I need an aluminum clutch cover made. So anybody making em?

You will be fine with the plastic one , i still have my stock plastic cover over 3 years old

^ Doesn't seem helpful.

Brady I thought you had a MM exhaust?? PM takem mark and talk to him.

800 hrs between my 2 motors same covers. 600 on my single same cover. You use the reverse lever right you won't have issues. If your cover is getting hot not only are you fucking up your cover you ain't getting full reverse!!

I'm pretty sure this has to to with the heat from a "Crossover" exhaust

The MM should have a heat shield on the bottom barrel.

The Crossover outlet points right at the top corner of the cover, sometimes causing it to melt.

Takem no longer does the covers, at least that's what I've heard. Instagator911 was planning some, not sure if it's still on the table or not.

I do have mm exhaust and mine has not melted off . All I'm saying is some ppl think they need them all I'm saying is you don't

I drilled the holes bigger and added two holes in the middle it guess that allow more heat out of it

Brady to be honest if your making heat in there, something isn't right.

How was your EVT melting your cover???

I not making heat I still have my stock cover , just to be precautionary is why there are extra holes

It only really affected it on very long consistent running but it did melt it, just from the main barrel

Must have had other issues, been running mine 4-5 hours at a time with no problems.

hmmm could have

I bought an aluminum cover and sold it without putting it on. I've had clutch cover issues but none from reverse. The first cover took a direct impact from someone's bow at a ride. The other time I had an exhaust malfunction that did a number on the cover.

now on the 23 thats a different story. with the crossover and the shorter block its melts the cover in a hurry.

Problem solved, got a buddy that's gonna whip up a batch from the design of "rocketman" cover.

This is how you get one made bring your plastic one to a fab shop it's not rocket science any fitter can make them for you

Well I always see threads that say where can I find an aluminum cover it's not hard just bring to local shop

Been trying to avoid the welding machine with this hot ass weather

If I could weld i'dmake some they always looking for them on here

Might try make one

Been saying I'm going to but haven't got motivated enough too.

For the amount of time it would take to build some covers, its gonna b hard to don't someone to make em and sell. I'm guessing that's why the last guy stopped making them. They are nice to have just cause they look better I think than the stock one. GT should just build em and put em on stock. Would make life a lot easier for alot of people.

I was goin to the camp and a beg fell on the foot pedal, I didn't notice till I turned around and the cover had 2' flames on it

I can make a cover if I had one to gt measurements from

Wait don't nail it I'm sure I know someone with a gtr

Mail

I have an idea in my head to make the design look sweet instead of a square cover, I'll work on it to make sure the clearances are right

Well you already know the Color was gunna be that

Really ?? Must have a low iq? Read the title of this thread ! Obviously ppl don't know how to get them build or where to go