Following the blind bag checklist, what do you all carry if you have to fix your motor? What tools and parts?

Extra fuses
....

8mm
10mm
12mm
14mm
7/16
1/2
9/16
Prop wrench
Spare prop( don't know why because I don't have a spare nut!!)

Don't forget zip-ties and duck tape.

-full set of tools.
-enought spade fittings and spare wire to rewire the motor.
1-wire strippers
1-pliers
1-vise grips
1-needle nose pliare
6-screwdrivers
-1 ballpeen hammer
1-WD-40
1-Electrical volt meter
-pliars
-extensions
-spare prop
-spare prop nut
-prop wrench
-spare switches
-extra oil
-extra spark plugs
-feeler gauges
-super glue
-apoxy
-25' of rope
-electrical tape


I hunt in the nasty conditions up here in PA and NY. Ive been cought in bad places and broken down on numerous occasions. I can pretty much fix anything on the motor with the toold and items seen below and I'm sure I have a lot that is missing from the list.. Nothing in this list is going to save you more than routine maintanence...

Oh ya... and about 75 zip ties of various colors and lengths.

all of the above plus calens phone number

Forgot needle nose vise grips and a pair of channel locks.

-Adjustable wrench, 10, 12 & 13mm boxed ends, screw driver, wire dikes, hammer, basic tools to work on whatever and a leatherman but not the tool shed...
-Electrical tape, zip ties.
-Couple of hose clamps and a brass barbed coupling in case a fuel line gets a hole, or the oil cooler busts.
-Spare gas bulb, had the barbed nipple break off one night and the didn't know until the motor ran out of gas, could not get the sob primed back.
-Mikuni rubber boot, original still looks fine but read too many having them crack...
-Super glue gel. Actually glued the plastic barb back in the bulb that broke and it held, plus if you get a deep cut it goes along with the first aid kit.
-Stick of JB waterweld. May or may not get me out of a bind one day. Plenty of sharp jagged rocks around here

Spare Motor!

Spare fuel pump
Trim switch
Throttle cable have broke 2 an it sucks to tryin to stand in back of the boat an drive an push the throttle lever on the carb

Blue loctite, full set of sockets and wrenches 8-15mm, spark plug socket, screwdrivers, 2 pair of channel locks, electrical tape, zip ties, a few spare nuts and bolts, quart of oil, carb cleaner, hose clamps, I'm sure I'm forgetting a lot of stuff.

Spare can of snuff or cigs incase u run out while broke down

i heard of guys carrying these too

http://www.ebay.com/itm/Drive-Belt-Emer ... 0875877802

JB weld should be a must for the sportV guys.

i heard the sport vs is gonna start comin with a rope n one of these smart thinkin

Every one needs a cresent wrench, it will save you ass!!

I carry a rachet and socket to fit everything on the motor I can handle on the water, some zip ties, electrical tape, various screwdrivers, a multitool, and a phone in a lifeproof case!