august landing.jpg

Square tube is easier to work with and cheaper then round tube/pipe

Here are a few we have done;

g.e.t.s.o.m.e

[attachment=-1]uploadfromtaptalk1397414546079.jpg[/attachment]

Sent from my SAMSUNG-SGH-I337 using Tapatalk

[attachment=-1]uploadfromtaptalk1397465379497.jpg[/attachment][attachment=-1]uploadfromtaptalk1397465395705.jpg[/attachment]

Sent from my SAMSUNG-SM-N900A using Tapatalk

I like how they hang over the sides. Do they fold in a little for running?

no, they stay like that, ive yet to use it yet, i just got this boat. actually just finished wiring up the trolling motor and lights. hopefully will find out how good it works soon

Hey Willet, I see that some of the setups that you have done are with square tubing and that some are with round tubing. What size are each, and is the round tubing just fence post tubing but bent? If so, how in the world did you bend it? I am in the process of building a railing for my platform and was thinking of doing the round tubing because I don't have a welder, but don't know how to get a bend like that. Any info or advice and where to get these materials would be helpful. Thanks

Not sure what you are talking about fence post tubing?

Round is 1" aluminum conduit because most aluminum pipe is too hard to bend at a tight 90 radius.

I have a pipe bender bought from harbor freight. Not the best in the world but it does what it has to

Sq Tube is a mix and depending on what customer wants or if doesn't specify most time use 1.5" x 1.5" x 1/8 thick

sometimes use 2x2x1/8 or 1x1x1/8.